Discussion Locked

How can I change com port for modem?

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am running win 98 SE and I need to set my modem to com 1-4 so that my software can communicate but the modem will not go to an open com port. When I add com 2 and 3, the modem will automatically move to com 5. Otherwise the modem defaults to com 3but the app says that port is not open because it has not been added.

Thank you for your help.

11 replies

by dmiles

First open the CMOS Control Panel and see if the ports are enabled in the Bios.
To change the port,Click Start--Settings--Control Panel,double-click the System icon,select Device Manager tab,locate the modem in list,click the plus sign next to modem and then higlight the modem,click the properties button,select the Resources,then uncheck box use automatic settings select change settings button,click the arrow next to box and see if ports are listed.This should allow you to change the settings.

by shaun

Thank you but I have tried all of that so far. The com ports have been enabled and when changing setting you are only able to change I/O address and mem address and irq but not the com #.

Thank you though.
much appreciated.

by ð

have you try removing all the com ports in device manager and disable the com ports in the BIOS settings?

by mphoffar

This really depends on the modem. Most of the PnP types I've dealt with usually have a jumperon the modem itself that'll allow you to switch between PnP and static addresses.

The other tpes I've worked with required a utility to manually specifya com port that the modem would use. Most softmodems and PCMCIA card modems are like this.

It would be a lot more helpful to know what kind of modem this is, to provide a better answer.

Mark

by dave5168

It may just want you to load a standard comm port driver for the port that the modem will be using. Or a bit obscure but you could be using a slot that is reserved for IDE (ATAXX)usage. Some ABIT motherboards use slots 3 & 5 for ATA66. You can'tuse those slots if ATA66 is used. Like I said.... a bit obscure.

This discussion is closed to new replies.