14 replies
by jimmy
If the system is Windows 95/98 from the msdos prompt tpye ipconfig /all.
If it is Windows 2k or XP from the start run command tpye cmd and when the window appears type in ipconfig /all from there.
Hope this helps
by timwalsh
Without knowing what type of network you are running (Windows-based, Unix/Linux-based, Netware-based, etc.) it's really hard to determine what tools you might have available.
In general, there are two protocols that deal with MAC addresses: ARP (Address Resolution Protocol), which resolves an IP adddress to a MAC address, RARP (Reverse ARP), which resolves a MAC address to an IP address. RARP is really only used by diskless workstations.
ARP can be used to determine whether a given MAC address exists on a network, but not directly. It will not allow you to SEARCH for a given MAC address.
Every computer maintains an ARP table that lists the IP addresses and associated MAC addresses of computers that it directly communicates with. Generally, the only computer that EVERY other computer in the network communicates with is the Domain Controller. If you run the command from a command prompt, a copy of the current arp table is returned. You can then manually search the list to find the MAC address in question.
This method is not foolproof. The ARP tale is periodically refreshed. Just because a given MAC address isn't present in the ARP table doesn't mean it doesn't exist on the network. The device with that MAC address may just be powered down. Also, the ARP table can have static entries added to it. Therefore, just because a MAC address shows in the ARP table, doesn't mean that it physically exists.
There are no other Windows-native tools you can use.
by pesk, mbcs, mcse, mcitp, sts
Answer no. 1-Will only give you information about the IP stack on which you typed IPConfig, not other external ones...
Answer no. 2-In addition to Tim Walsh's answer which is spot on, type [ arp -a ip-address ] to get a specific ip address's physical (MAC) address.
by pesk, mbcs, mcse, mcitp, sts
Go to Start, Control Panel, ADministrative Tools, Local Security Settings, Security Options and under Policy, scroll down to
[Interactive Logon:Do not display last Username;Disabled].
Since this is an explicit setting this has to be set to ENABLE in order for the registry hack to work. Meaning? You have to actually 'deny' access to the system to show the last username and since password caching is done on a username/password basis, if the username is missing, the password is discarded.
by pesk, mbcs, mcse, mcitp, sts
by pesk, mbcs, mcse, mcitp, sts
Just in case you are interested, this was in answer to the following thread;
https://www.techrepublic.com/forumqa/thread_detail.jhtml?thread_id=125648
by voldar
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending