Discussion Locked

How can I test cat5

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I'm connecting a peer-to-peer networking running about 25ft of cat5 cable. Once I crimp the RJ-45 clip how can I test the cable to see if I have a good connection? Is there a tester I can buy, and if there is where can I purchase one. Or can I make a tester.

8 replies

by dmiles

Try using a multimeter and making contact with the power and ground contacts and then do the same at the other end any reading from the meter will show that you have continuity through the cable.
Insert in the NIC card on each machine to see if the led comes on at each computer
Hope this helps

by mdl3

You could buy a Fluke cable tester but the really nice ones are like $700. go to fluke.com or there are some very generic cable testers, you could by one st your local ellectronic store.
Now you could PING from one workstation to the other to test connectivity! that will tell you if your straigth through cable (IF using a hub)or cross-over (IF conecting NIC to NIC)is working properly. ping using MAC address or set up a temporary IP address for testing purposes and use that IP address to ping.Hope it helps!
I

by jereg

You need an ethernet cable tester. You could build a tester useing an ohm meter, I've done it, but all that tests for is continuty, if the cable connects at both ends. The biggest problem is cross connects. That is where the cable ends in RJ-45 connector are a little too close together. The electorns cnan jump from one wire to another, but you'll need a tester for that. You can get them just about anywhere, but be careful. CompUSA will sell you a cable tester for about $100. It can be purchasedanywhere else for half that. I like to use Computer Discount Warehouse: www.cdw.com
You can get a low end cable tester for $50 (#125645). It will check for opens and shorts in the cable. If you can spend a litle more, check out the testers by Microtest: www.microtest.com
I like their tools. A Micromapper is about $90, do the same test as above, plus a couple more, including checking for cross connects. Not a bad tool for the money. If you can really splurge, check out the Microscanner at about $280. It provides the same tests, will map your cable, produce a tone for tracking with a tone probe. After that, you move into the network testers type of tool, and prices there start at about $1000.
Hope that helps.

by gday

for all things related to cat 5 testing go to www.cabletesting.com this site will show you how to wire correctly as you need to use the correct pairs on the correct pins.if not although you will see a pin to pin connection (wiremap)you will find that you will be subjected to NEXT ,CROSSTALK,SPLIT PAIRS.so even connecting up the NICS together will not always proove if you are cabled up correctly because if you have too much noise on the cable then the signal will not be seen by the NIC

by otl

First off if you crimped them identically on both ends it will not work (TX and RX will be on the same conductors on both NICs!) Have to roll pins 1,2 with 3,6 (I think, I know need to go back to ethernet 101) on one end.

by wlbowers

Buy an inexpensive tester. You will go nuts using an ohm meter. The testers show crossed pairs, shorts, and of course opens. The better testers show cable length as well.

And you don't need to cross pairs. The connections are the same on both ends of the cable unless you are doing a crossover cable.

Good Luck Lee

This discussion is closed to new replies.