Question Locked

How to configure Cisco 2950 switch port for uplink to Dlink DES-1024 switch

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a cisco 2950 switch which I would like to uplink to a Dlink DES-1024 unmanaged switch.
I understand for connection between two cisco switches we create trunk ports on both switches. How about connecting the Dlink DES-1024 unamanged switch to a Cisco 2950, do we make it a trunk or just have it as an access port?

3 replies

by cmiller5400

Since you won't be passing VLAN's, use "switchport mode access"

by dmaisu

Thanks for that info. I'll do that and hopefully all will be good

This discussion is closed to new replies.