Question Locked

How to connect MD110 using Cisco 2811 Voice Getaway

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

i want to connect two Ericsson MD110 via cis co router 2811. can anyone here help me how to configure the router so that the two Pbx can communicate. the network topology is similar like this :

Pbx--->2811---->(2Mb/s Leased Line)---->2811--->Pbx

For info, i'm using VWIC-1MFT-E1 for both router.

tq

2 replies

by cg it

you should be using the standard RS 232 on between the Unity server and your MD 110.

Cisco has a whole set of articles on configuring Erricson MD 110 to work with Unity.

If your not using Unity, what are you using for Call Manager?

If your using your 1811s as gateways what IOS version ? does that support telephony?

Leased line or POTS you have to use an IOS that supports telephony [Call Manager]and the correct VWIC for the line. [Non FXS and FXO]

BTW your VWIC-1MFT-E1 is ethernet and I'll bet your leased line is a T1 soooooo

might consider a VWIC-1MFT-T1

This discussion is closed to new replies.