Question Locked

How to Enable DHCP on NIC Card.

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Dear All,

I have Windows Server 2003 SMS and i have installed AD,DNS, & DHCP. Problem is that DHCP server not able to give IP address to Client.

On Server side everything is okay, but when i was checking ipconfig /all command in command prompt and i notice that DHCP Enable -- NO.

How do i make DHCP enable Yes.
Where do i check & make it enable.

Thanks a lot in Advance.
Shri !!

4 replies

by computercookie

Go to Network Places, view network connections, right click and select properties, click on TCP/IP, click on properties.

Obtain an IP address automatically should be selected, if you go to advanced settings it dhould tell you under the IP settings that DHCP is enabled.

by shriankush

Thanks for reply.....

Actualy i have different problem. As i explian that i have a Windows 2003 SBS server. I have installed AD,DNS & DHCP on Server 2003 SBS & they are working perfectly and no error in my Events.

When i connect my Labtop to my hub and that hub is connected to my server. As per DHCP i suppose to get IP address from my DHCP server, but i am not getting IP address from my server.

I don't know where is the error, i have check following things on my server.

1. Check Event log & no error
2. Check DHCP log file & no error
3. DHCP is Authorise in AD
3. DNS is Dynamically update
4. Check cable & cable is good.

Could you tell me where i am making mistake.

Thanks in Advance.

Shri !!

This discussion is closed to new replies.