Discussion Locked

How to identify/stop a broadcast from PC

0 helpful
13 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
On our small LAN (Win NT 4.0 server) there is one PC (Win NT 4.0 wkstn) which has begun some sort of broadcast daily, according to our Observer. This same PC is now unable to access the Internet through the LAN (worked fine before), yet is able to access all other LAN features. I have run diagnostics on its NIC, which seems to have checked out fine. Any ideas what else I can look for before I pay for expensive outside support?

13 replies

by russell ashe

Have there been any software hardware changes to this system or even OS upgrades that may have contributed to this new problem

check you event logging to see...client and server

by dkaym

The only OS upgrades would be recent security patches from Microsoft. They have been applied to other NT PCs without the same effect.

by russell ashe

Just try a simple uninstall and reinstall of the NIC. Be sure to remove the driver too and install all protocals new with the NIC.

Might save you.

by dkaym

I managed to find and stop an application that was causing the broadcast. However, there's apparently no connection between that and the inability to access the Internet from that PC. I ran the repair option on IE (v. 5.5), but that didn't change anything. Help!

by davidkestner

I had a serious problem of not being able to get on internet with ie, but the LAN worked and I was able to use another browser to surf. Did u check the simple stuff 1st to make sure u didn't change anything. Lasty, ping a sight out side your lan and see what happens. Let me know

by dkaym

I've checked the IE LAN settings and the Advanced settings, and they are identical to those on a PC with same version of IE and succesful Web access.
I pinged the same site from both PCs. On the trouble PC I get a message of "Bad IP address" while on the good PC I get the usual replies.

by svrarvind

Hi,

Please check if your deafult gatewat is set properly and also check if any Proxy Service has been added to the IE.

Please let me know how u connect to the Internet.

Lan Broad Cast happens if it is HUB Connection so there is no point in Questioning that.

by dkaym

The default gateway is correct, and the LAN settings in IE are correct. We connect to the Internet via a fractional T1 (256k).

by ziminski

If your can't ping a FQDN but you can ping an outside IP address then the problem lies in your dns configuration.

by dkaym

I did remove it from the adapters list and removed the driver files, then rebooted and reinstalled. That didn't help, so I guess I may need to try removing it and installing a PCI NIC.

by russell ashe

I think you are correct try PCI and see.

Disable the integrated or remove it all together.

Should just be pin connected ---depending on model

Good luck

This discussion is closed to new replies.