Question Locked

How to make a wired and wireless network?

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Hello, I got a new lap top and this one came with windows vista, I have a local network of three pc's (all runing XP). One of them is wireless conected but all of them run correctly, but I can't make my new laptop with windows vista to connect to this network wireless (I haven't tried wiring the laptop). This laptop works ok on internet but no with my network, i have configured but it wouldn't connect, it just connect to the pc conected wireless, please could someone telme how to do this? how can I connect to my local network? I need it to print and transfer files... pleas, please, help me.

3 replies

by p.j.hutchison

Run IPCONFIG /ALL on your new laptop and see what IP address you get. Then run the same command on another pc to see what it gets.

Do the PCs get their IP address via DHCP (DHCP Enabled = Yes)?
What IP address range do you use? 10.x.x.x or 192.168.x.x or 172.x.x.x or some other?
If you get 0.0.0.0 or an APIPA address (169.254.x.x) then it means you do not have a DHCP server running (prob from a router or modem).
If there is no DHCP, then you need to configure IP address for your new laptop. Use a different IP address, but the netmask, gateway and dns addresses should be the same.

by jim.richmond

I had a similar problem getting a Vista notebook connected to a wireless network. It would see the wireless router but would not let me specify the protocol or give a username and password for the connection. Instead of letting Vista auto configure the connection I created the connection manually and it worked fine after that.

Hope this helps.

This discussion is closed to new replies.