Question Locked

How to seperate external IP addresses?

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi again, friends at TechRepublic! I am setting up a simple SSH server for remote access. The server is just an old computer that I set up that runs off my network. (It's not a big server, because I don't need it) So, the problem is, I go to a website like "InternetFrog" to see what my external IP is. It says my IP, lets say... "11.222.33.44" (obviously not the real address), but when I saw my external IP on another computer in the same network, it was still "11.222.33.44". Also, when I tried to connect to the server with PuTTy, it says "Failed" I assume it's because it doesn't know which networked computer to connect to, because all 5 of them share the same external IP address.

Is there something I can do to fix this?

Thanks!

3 replies

by Former member

Clarifications

by jdclyde

Network Address Translation.

It is a forwarding of hits on the "real" IP address on the external network, to the internal address of the server.

Of course, if you do this, is there a DMZ port on your router? This would separate the server onto it's own network, because if you can get to it, so can anyone else.

by Former member

Thank you for the advice, I'm not on the network right now, so I'll have to check that later...

This discussion is closed to new replies.