Question Locked
0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have been trying to install SBS 2003 R2 on my new ML 150 server and I get prompted for the floppy via F6 and it reads the floppy just fine, but then after choosing the partition, accepting the EULA via F8, it prompts for the disk again and refuses to send the signal to the floppy disk to ascertain the driver. The HP is using the embedded Sata controller and there is no 34 pin port for the floppy. I am using a USB floppy drive. I cannot get past the prompt for the Adaptec driver and cannot load SBS 2003 R2. Any suggestions? I do plan to call HP in the morning and ask them what is going on. Or should I start with Microsoft instead?
4 replies
by hughie Accepted solution
Clarifications
by oh smeg Accepted solution
Failing that you can make your own Install Media by following the directions here
by hughie Accepted solution
is the only one which will work. No floppy port on the motherboard. The upside for me is they will deliver a loaner floppy drive next business day and pay for return shipping. The downside for me is yesterday, a holiday, is when I had the issue so it's not really next business day.
by oh smeg Accepted solution
Like for instance the above link while mainly aimed at XP will do the same thing with 2003 as with XP and will make you a Install Disc that is effectively the same as the ones that HP supplies without any problems that may arise from requiring USB Drivers at that early stage of the install. I don't know if that will be an issue here but it is sometimes.
Col
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Unanswered
How Can IT Teams Detect Hardware Bottlenecks in Business Networks?
0 helpful
0 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies