Question Locked

HP ZE2000 backlight will not work on battery power.

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a HP ZE2113 laptop with a new backlight installed. The laptop works fine on AC power but when you try to operate it on battery power it lights up for about a second before going dark. Is this related to the LCD inverter or is this another problem?
Thanks in advance

5 replies

by mjd420nova

Many laptops have a power conservation setting that allows for dimming of the backlight when using the unit under battery power. Some have a power conservation setting that will allow a time limit setting or a battery charge level to control the dimming of the backlight. I have a Dell Inspiron 7000 that does this. When the battery is being used and the level drops below 35% it dims the backlight to save the power left and alert the user that charging is needed.

by oh smeg

Most NB's will make the screen dimmer when running on Battery Power to extend the battery life as long as possible.

There may also be a Key Combination to press to toggle between making the screen darker or lighter and this would be listed in the user manual. You should read the manual to make sure that there are no hardware switches first involved and use them as the first option if there are.

However if there are not you can go into the Power Settings shown in the Screen Saver Windows and alter the way that this unit works when on Battery.

Here I'm assuming that the Battery is working correctly and has not started to go off and need replacing. Have you checked that out first?

Also check out the various Manuals available for this model on the HP Web Site here the Service Manual may prove very useful to you here.

http://h10025.www1.hp.com/ewfrf/wc/manualCategory?product=468549&lc=en&cc=us&dlc=en&lang=en&cc=us

Col

by ohc4

I have checked all of the settings and they do not seem out of the norm. I downloaded and ran the HP battery check program and it says the battery should be replaced. It will boot on battery power, just no backlight.

by oh smeg

To run the NB with correctly. The fact that the system runs but can not power the screen tells me that you have a Faulty Battery. This besides the Optical Drive is the most power hungry part of the NB when it is running. The Screen consumes more of the higher voltage battery power than anything else.

Even the HDD and Optical Drive only run at 5 V DC where as the Monitor uses the full output Voltage of the Battery to work. I would say that the voltage of the Battery is down to below the threshold required to operate the Screen.

Col

This discussion is closed to new replies.