HSRP configuration for vlans
Hi,
I have cisco 4507 L3 switch configured with vlans(Layer-3). I want to configure HSRP( vlan based) with another 3500 L3 switch using HSRP groups as there are 68 vlans. Kindly help on this.
Regards,
Santosh
Networks
Hi,
I have cisco 4507 L3 switch configured with vlans(Layer-3). I want to configure HSRP( vlan based) with another 3500 L3 switch using HSRP groups as there are 68 vlans. Kindly help on this.
Regards,
Santosh
by santo_1232000 Accepted solution
by deepu_dosey Accepted solution
HSRP stands for Hot Standby Router Protocol, and what it does is create a virtual IP address (which hosts will use as the gateway address). This virtual address is free to move between configured routers as needed.
Some background for this config:
Local Subnet: 192.168.2.0/24
Desired gateway address: 192.168.2.1
Both routers and their hosts must be on the same layer 2 network.
On Router A:
ip address 192.168.2.2 255.255.255.0
standby 1 ip 192.168.2.1
standby 1 preempt
standby 1 priority 110
standby 1 authentication myrouter
standby 1 track serial 0/0
The priority number determines which router will normally have the virtual IP address, higher numbers win.
The track statement tells the router to give up the virtual address if the serial 0/0 interface goes down.
Router B:
ip address 192.168.2.3 255.255.255.0
standby 1 ip 192.168.2.1
standby 1 preempt
standby 1 priority 100
standby 1 authentication myrouter
standby 1 track serial 0/1
That's all there is to it! Router A will host the virtual IP address, and if the router or it's serial port goes down, Router B will assume control of the virtual address, and traffic will flow over it's serial link.
by eliascharles4d Accepted solution
your two switches
Standby ip add XXXX YYYYY
Standby prembt
standy Pritory whis swith you need primary set high prioty
Stand by track
Regards
B.Charles
This discussion is closed to new replies.
Sort by Trending