17 replies
by dwinz Accepted solution
by nexs Accepted solution
1: Has the server-side application been setup properly?
2: Has the client-side application been setup properly? (ie: may be a setting that depicts the server name or address)
3: Is there an application service supposed to run from the server? Have you checked services.msc?
by jgirizarry Accepted solution
Assuming the error message you posted is coming from the HR application when you open the program and not knowing the software you are using, I would recommend to check if you need to map from the clients to the correct server folder in order for the program to work. Some server side applications might even need to map itself in order to work. In other words you might need to create a mapping drive from the clients to the server, unless, the setup configured the server side during installation. Anyway, check the manual because if you have remote access and you can PING, the network is fine and it could be a setup error. Disable any firewall and retest.
Cheers
by dwinz Accepted solution
by nexs Accepted solution
by jgirizarry Accepted solution
by dwinz Accepted solution
by dwinz Accepted solution
by jgirizarry Accepted solution
by dwinz Accepted solution
by jgirizarry Accepted solution
by dwinz Accepted solution
by nexs Accepted solution
Well without knowing the software and being able to see both client and server applications, i'm afraid i'm out of ideas.
sorry dwinz
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending