Question Locked

I can't connect to internet when the connection 2 is enabled

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have two pc's connected via cross over cable with pc1 192.168.0.1, 255.255.255; pc2 192.168.0.2, 255.255.255.the two pc's communicate very well. the problem is that i can't acess the internet, only acess is possible if i desable the connection 2.The connection to internet is configured to obtain IP automatically.Could someone help me i need to have the two connection working as i need the internet in both.

2 replies

by noelrd

First off, you have static IP addresses and then you say that your connection is configured to obtain IP automatically. It's one or the other. I am assuming that you have two nics in PC1 and a third nic in PC2. If that's what you have, then one nic handles the internet and one handles the connection between the two computers. Then, you need software to do the actual routing. You can even use Microsoft's internet connection sharing software called ICS. You can get to that in different ways depending on which Windows OS you are running. It has been around for a long while and it is pretty easy to use. Hope that helps.
If you have already done all that, then you may have an issue with your DSL or cable modem trying to act as a router. In that case, keep the setting to obtain an IP address automatically on both computers. Then reset your modem and (if needed) possibly do an: ipconfig /release and then an: ipconfig /renew on each computer from the command line. That's about all the help I can give with limited information.

This discussion is closed to new replies.