Discussion Locked

I have a hewlett packard model # XG833

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
my hewlett packard computer has a software build of 12NARCKT04, i purchased it about 5-6 months ago. I cannot get it to do a complete defragmenting of the c drive. It will go to 10% then i get a message that windows cannot defrag this drive because it cannot access part of c drive. I have windows me on it. It tells me to scan disk thorough/ auto fix errors. When i do this, it will scan only 1,221,725 clusters out of 1,245,371 then stops. so i have never been able to get it to defrag. h/p hasnt been of any help. I have even had protonic tryin to figure it out. Do I have a defective computer hard drive? I am at my wits end. Please if you know why i cannot scan disk or defrag my computer, i would appreciate an answer. Thank you for your time. Verla

5 replies

by teknik

That's absoloutly a hardware fault.If you take your computer to an Authorised Support Provider they will change it immediately.I am working as a HP technician in an ASP of HP.And I see this or like this problems very often.It's because of your harddrive.Have it changed.Good Luck

by hamiltonreps9aa

If you have too many programs running in the background scandisk and defrag will not finish. Just Crtl-Alt-Del and close all programs then try it again.. If this does not work try formatting the drive.

This discussion is closed to new replies.