Question Locked

Ide drivers not been seen

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I'm trying to get a old computer up and running again and when I boot it up I notice on the post boot up screen it in no seeing any of my ide drive my hard drive and cd rom drive. I have tried to replace the ide cable and even went so far as replace numerous hard drives.

5 replies

by seanferd

If it is not set to automatically detect drives, it will not detect anything.

It may not be able to detect newer drives at all, and even if it does, it may be limited in the size of the drive you can use.

If a BIOS setting doesn't help, please post the computer make and model, or the motherboard model, and the make and model of drives you are trying to use.

It could be that the motherboard is damaged as well.

by oh smeg

IDE Drives Have a Jumper on them so that they can be set to Master, Slave or Cable Select or CS. If you have 2 IDE Drives on the one IDE Cable both set to the same Jumper Setting the drives can not work.

The Jumper consists of 2 rows of 3 or more pins and with the current generation IDE Drives these are between the IDE Leads Socket and the Power Socket on the back of the HDD. But older HDD can have these on the Circuit Board on the Bottom of the Drive it really depends on just how old the HDD and M'Board is here as to where you need to look. But on all but the oldest Drives the Sticker on the HDD will have the settings and where this Jumper Strip is Located.

You need to have any HDD set to Master and if the M'Board is new enough to support a 80 Wire IDE Lead on the End Connector and the Optical Drive set to Slave and on the Middle Connector again if the M'Board supports a 80 Wire IDE Lead.

Then depending on the Make & Model of the M'Board BIOS can only support certain Sized Drives without knowing the Make & Model of the M'Board it's not possible to advise on just how big a Drive can be supported by the BIOS so you'll need to post back with that Information or the Make & Model of the Computer if you do not know the M'Boards Maker.

In a worst case scenario we may even be able to give you a rough guide if you post the CPU Type and speed but to be perfectly honest the M'Board or Computer Make & Model would be best.

Col

by mdmmedlang

OK this was a home built PC that is about 4 years old. This is the model number on the mother board V400ADBL Im not sure who makes this motherboard. I think it may be the jumper setting like you posted above. I Had my hard drive set as the master and the cd rom as the slave. But i hade the ide cable set in the opposite way. I will set them correctly and let you know how it goes. I will post back within a couple of weeks when i get time to fiddle with the computer. Thanks for getting back to me and Have a great day.

by seanferd

The optical drive on the same cable as the HDD will slow down the data transfer rate, if nothing else.

This discussion is closed to new replies.