Question Locked

IDE HD's connected via SATA converters not detected in BIOS

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I recently upgrade motherboards and am trying to connect 2 IDE HD's via the SATA connectors using IDE to SATA conveters...the drives are not detected in the bios??? I've tried different jumper arrangements on the the HD's without luck...anyone got this this figured out yet...I see alot of other people with similar problems???

5 replies

by oh smeg

Converters and then pull the M'Boards SATA Drivers out of the Packet.

You'll need to start to install the OS and if this is either XP or Vista at the first Blue Screen pres the F6 key to tell the computer that you need to install extra drivers. At first there will appear as if nothing happens but when this process of identifying the installed Hardware finished you'll be prompted to insert the SATA or RAID Drivers into the A Drive and allow them to load from there. The system will then continue to install the Windows OS without a second though.

On most M'Boards the SATA Drives are not seen in BIOS just like SCSI Drives or Optical Drives are not seen in BIOS.

Col

by donlamothe

Tried that several times...the OS install (XPpro) get's to a point where it states that there are no available HD to install on before it ever asks for the SATA drivers????

by brismac

1Sata drives do not use master/slave jumpering 2.XP pro,and some mainboards, are funny with this type of install, but you can do it after the OS is in too. You must have the floppy with the drivers on, in the drive. Then use 'add hardware' in control panel. You may have to play around with the options that come up with what and where to install from. If this does not work try clicking an exe file off the floppy disc. Hope this helps.

by oh smeg

Though you may mis the question as on the very first blue screen you are asked to press [b]F6[/b] to install and SCSI Drivers which in this case also means SATA Drivers or RAID Drivers.

When you press the [b]F6[/b] key at first nothing will happen but when The Windows Installer gets to the end of that part of detecting the available hardware it will then ask you for the Drivers that you have told it that it needs. These need to be copied directly to a Floppy without any folders so you need to copy the correct SATA Drivers for that OS which is most likely the 32 Bit OS and then place them directly without a folder onto a floppy.

Col

This discussion is closed to new replies.