8 replies
Look at this link to the experts exchange site, and review all the replies to a very similar problem. It looks as though this resolution may work for you as well.
http://www-level3.experts-exchange.com/Operating_Systems/Win2000/Q_20743490.html
or
REMOVE SPACES from the pasted URLs.
REMOVE SPACES from the pasted URLs.
REMOVE SPACES from the pasted URLs.
REMOVE SPACES from the pasted URLs.
by adam
Poster rated this answer.
Well Thanks I'm sure this is a great site, Just don't feel like registering for the membership. I did however notice that somone had the same problem I did. I have resolved the issue shortly after submitting the question. The computer was brand new out of the box no operating system. I loaded Windows 2000 And it ran great till I did the service Pack 4. I do not know what that service pack does with the boot secuence or ide configuration. Well heres what I found and did to resolve my dilema I looked that the hard drive jumper setting Hence the Inaccessible_boot_device error. The hard drive had two jumpers on it maybe a manufacturing error from the factory one jumper was set on cable select the other on master with slave present there was a schematic that showed single or master with no jumpers so I took both Jumpers off for a single master setting VIOLA it booted.
by john.keddy
I think this could be a hardware conflict. check your hardware. It sounds like this is either your cdrom or vidoo card.
Good Luck....
by adam
by flan
by adam
by adam
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending