Question Locked

Increasing memory breaks system

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have 2 (nearly identical) windows 2000 servers with 512 MB RAM. When I increased the RAM to 1024 MB odd things started to happen. Programs that load at startup don't always load. The 2 servers don't see each other on the network. Low system resource errors. Access rights errors when using the policy editor. On the 1st server I tried 4 - 256 MB modules (original 2 + 2 from second server). For the 2nd server, I installed 2 - 512 MB modules. When I went back to the original memory config. My problems went away.

This week I need to move the 2nd server to a new network. I installed 2 - 512 MB modules reformated the HDs and did a clean install. Things went okay until I was midway through installing Symantec Anti Virus Corp. Ed. Several modules would not install because of either a runtime error or were automatically terminated by Symantec. After reducing the memory 512 MB my errors went away and SAVCE installed correctly and the server is working find. Server specs. follow:

Mobo: Intel D865 PERLK (both servers)
CPU: Celeron 2.53 GHz / Celeron 2.8 GHz
RAM: DDR 400 / PC3200 Crucial (both)
Video: ATI Radeon 9200 (both)
HD: 2 - 80 MB SATA Mirrored (Seagate)(both)

Only a memory config. of 2 - 256MB modules seams to work. 4 - 256 MB modules or 2 - 512 MB modules does not work.

I ran memtest86 on the system when I had the 2 - 512K modules installed and the system passes.

3 replies

by cg it

sounds like the board doesn't like the memory.

This is not unheard of. Even as far back as the 168 pin SIMMs.

Here's the question: Is the crucial memory you purchased on the Intel site list of memory modules that will work with your mainboard?

see the technical product documentation on the 865 PERL mainboard [under desktops].

unbuffered, non ecc memory modules only are supported. Also check your BIOS setting for buss speed DDR 400 uses the 800 Mhz buss speed. If you previously had DDR 333 it's possible the buss speed is set at 533 Mhz which would make the DDR 400 not work properly.

by japeter

Intel's spec.:

The Desktop Board D865PERL has four DIMM sockets and supports the
following memory features:
? 2.6 V (only) 184-pin DDR SDRAM DIMMs with gold-plated contacts
? Unbuffered, single-sided or double-sided DIMMs with the following
restriction:
Double-sided DIMMS with x16 organization are not supported.
? 4 GB maximum total system memory. Refer to Section 2.2.1 on page 51 for
information on the total amount of addressable memory.
? Minimum total system memory: 64 MB
? Non-ECC DIMMs
? Serial Presence Detect
? DDR400, DDR333, and DDR266 SDRAM DIMMs

I crashed as burned using crucial memory:

512MB, 184-pin DIMM, DDR PC3200 memory module
CT6464Z40B

Module Size: 512MB
Package: 184-pin DIMM
Feature: DDR PC3200
Specs: DDR PC3200 ? CL=3 ? UNBUFFERED ? NON-ECC ? DDR400 ? 2.6V ? 64Meg x 64

Intel's page lists Micron:

512 MB Micron MT16VDDT6464AG-40BC4 Non-ECC

This discussion is closed to new replies.