Discussion Locked

install 2000pro error

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

i install win2000 pro into a dell ( PIII 500 ) notebook with 256mb ram . i delete all the partition and install from the beginning . The OS boot up perfectly and format the harddisk and copy all the the system files . When finish and the notebook restart by itself , the error " NTLDR " appear .

i can't solve this problem and faster way is to delete all the partition and reinstall but same error appear " NTLDR "

The notebook doesn't have any floppy drive , only come with cd-rom .

anyone any advise ..... ?

6 replies

by bobho

Is there only 1 partition on this hard drive and is it the Active partition. If not, w2k will not boot from it.

RW

by wfyeng75

i have check the partition , is set active . When i remove the Harddisk and plug to ibm notebook , it continue the setup . I feel strange , at last i setup the dell notebook with win98 operating system , it work fine . From win98 i try upgrade to window2000 . It show the same error " NTLDR " . Is it the hardware failure ?

any other advise ?

by rindi1

use a program like fdisk or partition manager to set your primary partition to "active". Also make sure you have a primary partition.

by dmiles

Many times this error is caused when the computer is attempting to boot from a non-bootable floppy disk or CD-ROM. First verify that no floppy diskette is in the computer, unless you are attempting to boot from a diskette.

If you are attempting to boot from a floppy diskette and are receiving this error message it is likely that the diskette does not have all the necessary files and/or is corrupt.

If you are attempting to install Windows XP or Windows 2000 and are receiving this error message as the computer is booting verify that your computer BIOS has the proper boot settings. For example, if you are attempting to run the install from the CD-ROM make sure the CD-ROM is the first boot device, and not the hard disk drive. Second, when the computer is booting you should receive the below prompt.

Press any key to boot from the CD

When you see this message press any key such as the Enter key immediately, otherwise it will try booting from the hard drive and likely get the NTLDR error again.

Note: If you are not receiving the above message and your BIOS boot options are set properly it's also possible that your CD-ROM drive may not be booting from the CD-ROM properly. Verify the jumpers are set properly on the CD-ROM drive. Additional information about checking the CD-ROM drive connections can be found on document CH000213.

This discussion is closed to new replies.