Question Locked

Installing XP on Vaio Laptop w/ External Monitor Only

0 helpful
18 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a Sony Vaio with a cracked (non-readable) LCD. Was using the laptop with an external monitor with no problems. Decided to do the annual Windows re-load to clean up the accumulated junk and now can't get past the initial install. I'm using the Sony recovery disks and everything is fine until the "remove the DVD and reboot" point in the sequence.

At this (and all subsequent) reboot, the Sony bios splash shows on the external monitor and then the Windows load screen. Once windows is loaded, the external monitor loses its signal and, I assume, switches to the LCD. Windows is running, since the music plays, but the fn keys to control volume, mute, display intensity, and external monitor are not yet functional. I've tried booting in safe mode, but get a pop-up saying windows is not done loading. The bios setup screens are very basic and I can't find anything useful there to control video output.

Any ideas? I'm hoping to get this laptop back into service before the new year.

Thanks

18 replies

by oh smeg

Only thing i can suggest is to leave it be for about 30 minutes and see if after that you can boot into Safe Mode. The Sony Recovery Disc should have included the [b]Hot Keys Driver[/b] as by your description the External Monitor is switching off after the Video Drivers are installed for Windows. If you leave it long enough it may finish loading Windows and provided you have not yet inserted a Log On Password Windows should start normally.

Maybe. :)

Col.

by techrepublic

The hour or so of installing Windows displays on the external monitor. Then the load process executes a reboot. The reboot shows the Windows load screen, complete with the back and forth bar. As soon as the load completes, the external screen goes blank. The LCD is lit and some music plays (not the Windows startup but five minutes of music). I'm assuming the laptop is waiting for some human input, but can't see what.

Thanks again

by hal 9000

Try pressing Enter and then if nothing happens press the TAB Key once then enter. Keep doing this till Windows Opens and you hear the Windows Start Music.

There should be a couple of steps here asking to Register and Turn on Auto Updates things like that. :)

Sorry but I can not remember if it is 2, 3 or 4 steps at this stage of the Windows Install Procedure. :(

Col

by ---tk---

From the looks of it, Sony XP installs are nightmares, and since your driving blind it doesn't help much either.

From what I have read on the net, even with the recovery disk, you still need to install the correct drivers... The Video & Hot Key and a couple other drivers that need to be installed also (after you install the OS)... So it makes sense that your external LCD doesn't show up, and your Fn doesn't work either.. The OS doesn't have the proper drivers...

Unfortunately, I don't have work around... other than to say get the LCD fixed.

by techrepublic

Wish there was a when you see this screen . . . kind of manual designed for the great unwashed. Would be handy in this situation.

by techrepublic

Thanks all. I tried several combinations of tab, space, and enter, thinking the first screen is probably the 'accept our terms' screen followed by a key entry screen at some point, but all to no avail.

I have an old Toshiba - I'll try loading on that and see if I can at least figure out the sequence.

By the way, I also tried a copy of my retail XP Pro disk, but couldn't get it to boot either - and can't find my original disk.

by oh smeg

When you hear the Music Windows is asking you to accept things. The first screen is to Register the product with M$ if I remember correctly and then there are a couple of others which I can not remember mainly because I have never paid them enough attention I just decline everything and then enable them after I have the systems fully loaded. There is one to Register Windows, another to turn on Auto Updates and that is all I can remember though I do think there is another one as well.

It may take a bit of messing around and lots or rebooting but once you get past this point you shouldn't have any problems.

Though it would be a lot easier to just replace the screen.

As the next time you do this the same thing is going to happen. :)

Col

by techrepublic

Have been through the process before, but didn't pay careful attention to all the steps. Turns out the retail version (of XP) works so I'm following that path - see the other branch of this topic. But, if I find someone else who is recovering a Vaio and has screen shots of the process, I'll switch back to using the OEM version

Thanks for the input.

by techrepublic

Though I am missing my working XP Pro disk, a neighbor had one and I was able to load the non-OEM version. Now I just have to figure out how to load all the drivers, especially the NIC card. Has been a while since I worked from disks

Thanks for the pointer to nlite. If this doesn't work, I may go there next.

by oh smeg

In a usable form open the Device Manager right click on the Unidentified Device Listing and select Update Driver from the Drop Down Menu and point the installer to where you have the Driver stored.

You will of course have to install any Software for your Hardware as per the normal way.

If you don't have the Drivers you will need to download them from the Hardware Makers Web Site possibly unzip them and then do the above.

Col

by techrepublic

and then I should be OK. I know the drivers are somewhere on the Recovery Disk. I just have not been able to find them yet. Once I do, and once I get the NIC card working, the rest should be easy. I may download the basic drivers on a different computer and burn a CD to use to get up and running.

Thanks for your help

by rob miners

to download the NIC drivers from the manufacturers site.

by oh smeg

This is because they are Slipstreamed into the I386 File on the Recovery set. [b]I think.[/b]

You can use the recovery set to install the drivers however by just right clicking on the device in Device Manager and selecting Up Date Driver and then point the installer to the Recovery Disc to find the drivers.

Hope that helps you somewhat.

Col

by techrepublic

using retail version of XP Pro, drivers from the Sony web site, and apps from the laptop recovery disks. Chatted with Sony support who confirmed there is no way to do the OEM recovery without the built-in display.

This discussion is closed to new replies.