Question Locked

Interconnecting Cisco 3560G switches

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I'm a new network admin with a small network infrastructure but little knowledge of why things were done the way they were. I have three 3560G switches that are connected from their SFP ports via 8 port 3500XL switch.

Port gi0/49 on each 3560G is configured as follows:

interface GigabitEthernet0/49
switchport trunk encapsulation dot1q
switchport mode trunk
macro description cisco-switch
no cdp enable
spanning-tree link-type point-to-point
!

Can I remove the 3500XL and connect the 3560Gs to each other via some sort of daisy chain cabling with the SFP ports?

Internet access is available through an appliance firewall that has a straight through cable connected to just one switch's port. What should be the best configuration for optimal performance?

Thanks,

-Chad

4 replies

by cg it

and you don't know what your doing, the best approach is to do nothing. If you do something and the users then can't get on the network, it's you who will get the blame.

by career

Sounds like the previous admin had setup the 3500XL as sort of a "Core" switch, which doesn't make sense. The 3500XLs are ancient and can't do many of the things the 3560Gs can.

You can connect the 3560Gs together directly using a special cable that Cisco makes. The part number is CAB-SFP-50CM

Once the 3500XLs unplugged, I'd recommend doing the following on the 3560s if not done already

1) Run rapid spanning tree (802.1W) with the command "spanning-tree mode rapid-pvst"

2) On the primary 3560s, set it to STP root with the command "spamming-tree vlan 1-4094 root"

by career

Run Loopguard and UDLD to protect yourself from Spanning Tree issues

spaning-tree loopguard default
udld aggressive

This discussion is closed to new replies.