Question Locked

Internet Connection problem

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello everyone, I have a problem which is very confusing, maybe someone can shed some light? I have a problem connecting to the internet, I have a Broadcom Xtreme network card in my computer which connects to a webstar dpx100 cable modem via an ethernet cable. Recently the local area connection says I have limited or no conectivity, I have checked the cable and it is fine. The local area connection looks as if it is connected but I have to use the usb connection on the modem to connect to the net. Does anyone know why this would happen?

Simon

7 replies

by ebranigan

connecting to another ethernet device? to ensure that your eitehrnet connection is working properly? Did you accidentally disable DHCP or set a static ip?

just a couple of things to check/try.

by deity_chooch

I'm going to say that any time you receive a "Limited or no connectivity" error, there's a 99% chance that it's due to DHCP not working (your 169.254.x.x address confirms this). If the cat5 cable is working and your computer is set up correctly (working, enabled NIC with DHCP enabled), then the DHCP server is at fault.

You may simply have to plug in using your cat5 cable (and unplug the USB) and power cycle the modem. If that doesn't work, you might have to call your ISP and see what they can do. Some ISPs require each CPE MAC address be authorized separately and if this is a new computer (or perhaps a deletion on the ISP's end), this may be the only resolution. It also may be a faulty modem needing replacement. Remember to test functionality of the cat5 connection _without_ the USB plugged in.

by 22048179042880848589126767153620-22048179042880848589126767153620

After taking your advice, i checked all connections, did a /release ip on cmd, disconnected the modem power, re-connected the power after about 10sec did /renew ip on cmd then pinged my ISP (with an average time of 26ms) and i am now up and running. Thanks for all your help everyone. Simon

This discussion is closed to new replies.