Discussion Locked

Internet on domain server, none on client machines

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a domain network where the two domain servers are able to get internet connectivity but none of the client computers are able to get internet connectivity. Everything was working up until we installed IIS so that we could install Symantec End Point. After that all internet on the client computers, all 47 of them, went out. I am still able to get online on the server but no where else... After all of this, then we started having roaming profile problems where the cleint computers couldn't find the server profile.... I think I'm getting in over my head and need help!!!!

6 replies

by maniacman

Check to see if the Symantec products isn't blocking DNS port 53 traffic from your workstations to your server. If the servers can get to the web, but the workstations can't, then it's a DNS resolution problem. Roaming profile problems also indicate a DNS resolution problem.

by chrisgoode

I have since uninstalled SEP but still have no internet connectivity... I have set the client machines to only use the domain controller for DNS... how would I go about checking to see if port 53 is being blocked by some residual settings from SEP?

by michael kassner

Just to verify that it maybe a DNS issue try using the IP addr of a website on one of the workstations. If that works, then the DNS/DHCP information is not getting published to the workstations.

I do not know the exact network topology, but you may want to check the results from the ipconfig command on the servers and workstations?

by cg it

it's tough to say what the problem is without knowing more on the topology e.g. does the DC act as a gateway or proxy?

What is used for the interface between the internet and your network e.g. a router/firewall? how is that configured? how do clients get default gateway information?

What is the default gateway? is that your perimeter router/firewall [which is should be] or something else.

by chrisgoode

Somehow the DNS service on the DC was disabled.... Once I reconfigured DNS, everything came back up right away... I guess my only question is how that could have heppened... everything was running fine until we tried to install Symantec End Point 11. Is this just a Symantec thing?

by maniacman

I wouldn't be surprised if your particular Symantec product was the culprit here. What do your even logs show?

This discussion is closed to new replies.