Question Locked

invalid system disk error

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have installed windows 98. but oneday I switched on my pc and got a error "invalid system disk error" .

7 replies

by stress junkie

The first thing that I would check would be to see if there is a floppy disk in the floppy disk drive. If there is a disk there that doesn't have an operating system on it then you would see a message similar to the one that you posted. The same goes for a CD-ROM although most computer BIOSes will skip past a data CD in the drive and try to boot from the hard disk.

Otherwise it seems that your hard disk has experienced some kind of a problem. It could be as simple as the boot block being messed up or it could be more serious.

If you have the Windows installation media then try to start your computer using that. You will be able to see whether the hard disk works or not using the Windows installer or rescue console.

by pavi.saggi

Hi shiva i think my other is right this problem can occur because of any floppy or CD might be there in the drives or if this is not the case then the MBR has gone bad so to fix the MBR we need to insert the bootable CD or Floppy and then we need to run the command "fixmbr" and then you can check it should work

by 1bn0

A bad MBR is possible but less likely.

Might be just be missing command.com or other system files. I found this to be a common problem with win98.

There is no recovery console for win98.

You can boot from the original cdrom and select:

"Start the computer with cd-rom support"

This will boot to a DOS prompt and load a DOS based cd-rom driver as well, so you can access files on the cd-rom.

At the DOS prompt type
sys c:

this will re-copy the boot files to your hard drive.

It should copy msdos.sys, io.sys and command.com.

You can check by typing
dir c:\ /a

do not try to copy msdos.sys or io.sys manually. They have to be copied to the right location on the hdd. That is what the sys command is for. If command.com did not get coppied , you CAN copy it manually.

by choikichon

IO.sys file is corrupted , so u should use bootable disk floopy and type command sys: c

by shiva_mishra85

dear sir,
my system boots from lan, when it comes on f drive before comming it shows "internal stack overflow , system halted"
afterthat hang up.
plz solve my problem.

by computacentre

floppy drive (test with a boot disk)or a virus considering its windows 98

This discussion is closed to new replies.