Discussion Locked

IP Address binding in Win 98

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a user with a Gateway system, Win 98 and a 3Com 10/100 NIC. Problem is, we run a DHCP server on campus that works fine for everyone ELSE but this user! She brought her machine from a previous location and there's an IP address and unique subnet mask bound to the card that I can't shake. Uninstalling and reinstalling network drivers doesn't seem to make a difference (nor the cold boot). Control panels show TCP/IP for that card should be getting the IP info from the DHCP server, but ipconfig in a DOS window consistently shows the old address/mask.

Anyone know a way around this? Will physically removing the NIC affect any address bound to the card, or do I have to find some obscure 3COM utility to make this change via software?

Thanks.

10 replies

by kep 001

WINIPCFG may be useful, have you tried it? Start/Run/winipcfg. Check on the More Info and see the IP address of the DHCP server.

Kep

by dlw6

Try removing the entire TCP/IP stack via Control Panel .. Network. Remove the TCP/IP protocol completely, reboot, install TCP/IP back in, and add the DHCP information.

Good fortune,
Don

by ann777

Run regedit and browse down to:
HKEY_LOCAL_MACHINE\System\CurrentControlSet\
Services\VxD\DHCP and remove everyting under this key.

Make sure that there are no other protocols or services installed that could be handing out an ip address based on something else. (for example, a PPoE adapter). Check modem settings.

Removing the TCP/IP protocol from everthing it is bound to. If you are not using IPX/SPX then remove it. Same for NetBEUI. Re-install the TCP/IP and see if rebooting gets you in the proper network.

by sblakeup

An additional note: this situation seems to have "fixed itself" overnight. Anyone have any good ideas why this happened?...like needing to leave the system off long enough for things to discharge and buffers to empty on the NIC? I made no changes, but the user called today to thank me!! :)

Scott

by chads

Remove the card completely, from net properties and from the PC itself. Restart PC. When you put the card back in, the only thing that should remain when you reinstall TCP/IP is the DNS info. Disable that and enable DHCP in the WINS config.

Hope this helps.

This discussion is closed to new replies.