Discussion Locked
0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
How can I delete a IP route on the cisco 2600 router. We have a encryption unit that is been transfered to a new location which is now connected to a new router. When I add the new ip route it has only a success rate of 60%. Which is maybe a cause of the previous ip route on the other router it is been connected before.
2 replies
I'm a bit confused on a couple of points. Has the old router been removed completely from the network? Are you using static routes or a protocol such as RIP or EIGRP? Does the encryption unit have its' own IP address and has this been correctly set to reflect that of the new router?? What do you mean by only a 60% success rate?? Are there any dial up links??
If you are using static routes, the command
NO IP ROUTE a.b.c.d a.b.c.d interface
should work to delete the old route.
Hard to say without looking at your config files
by prendph
This question was closed by the author
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending
Question
Floppy drive wont work on my 486
0 helpful
1 reply
Discussion
How to make light speed agent go away
0 helpful
4 replies
0 helpful
1 reply
Discussion Locked
Ryzen 7 7700
0 helpful
2 replies
Question Locked
Issue fully resetting my PC
0 helpful
4 replies