Question Locked

Is there a bandwidth limitation on wired/wireless routers?

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I read an article recently that though ISP sends data at higher bandwidth, the consumers will receive a lower bandwidth many times due to the limitation of the routers themselves.

I have seen that when I connect directly to my DSL modem, I can see a bandwidth of 8 MBPS and when i attach a wired router or VOIP gateway with router, I only receive 6 MBPS.

While surfing on web, I came across an article that said some routers/VOIP gateways limit the bandwidth.

My ISP's DSL Modem shows a speed of 8.5 MBPS and when connected to a router and performed a speed test, it showed me 6 MBPS only

5 replies

by dumphrey

And most consumer grade routers only have 10Mbps WAN interfaces, which translates to 8ish real bandwidth. I have never checked my modem to see if its rated different then my router.

It could also be they are using the modem to set your cap instead of their switching gear.

by ---tk---

I do know that I had a weird issue with my old router, which was a business class router, and it had all the bells and whistles... I was starting to see my games lag, which clued me into there was something going on... I ran a speed test on it, hit 3 Mb\s down and 100 Kb\s up... on a 15 Mb\s down and 1 Mb\s up line... long story short... I picked up a new router, and I am now hitting 22 Mb\s down and 1 Mb\s up...

by jdclyde

the SOHO and home model routers most buy often only last a few years before they start having issues. The first issue seen is usually dropping wifi connections.

Another thing to consider, wireless slows you down, both because it runs at half the speed of a wired network AND because it has twice the network overhead, so a larger portion of your bandwidth is just overhead instead of data.

I have actually seen where I have got a higher performance out of a decent router than plugged directly into the cable modem.

by robo_dev

But many have flaky firmware and/or wimpy processors, so often they cannot provide simple NAT routing at wire-speed.

Try upgrading the firmware in the router, setting it to factory defaults, and turning off just about any special features (e.g. logging).

Don't forget that most SOHO routers are typically NAT firewalls and most of them do stateful inspection....that all takes time.

This discussion is closed to new replies.