Question Locked

Issues with a management vlan on a Cisco 2950

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I'm having issues getting any traffic to pass through the management vlan and a 48 port Cisco 2950 switch.

The management vlan is separate from the native vlan, whose interface has been shut down.

All other vlans seem to be passing traffic normally. CDP neighbor information, and VTP configuration information is passing and the users off of the switch are still able to access the network. Also, there is one VOIP phone off of the switch that is also working just fine.

I just cannot administer the switch remotely and our network monitoring software keeps showing that the switch is down.

I've consoled into the switch a couple of time and have done shut no shut on the management vlan interface and the trunk port. I even tried changing the interface IP address. I've cleared the ARP and reloaded the switch several times. I still cannot ping or telnet into the switch and the switch cannot ping or telnet into any other switches on the network.

I'm out of Ideas at this point. Any suggestions would be greatly appreciated.

3 replies

by larellano

Set interface Vlan1 to no ip address and no-route-cache and then do a shut on the interface. Then the vlan your networking devices are on, set that interface up. Like interface vlan10 give it an ip address with subnet mask and then do a shut/no shut on the interface. This should get you back to pinging your device and will get you back to the management web interface if your switch has it. Hope this helps.

by tommy.staggs

I am having the same issue with the management vlan on a 2950. Did you get a fix?

This discussion is closed to new replies.