Juniper Netscreen 5GT
need to open up a port to allow me to connect to the network using Real VNC or some other remote software. Can antone guide me here?
TIA.......
Networks
need to open up a port to allow me to connect to the network using Real VNC or some other remote software. Can antone guide me here?
TIA.......
by synner
set service realvnc protocol tcp src-port 1024-65535 dst-port 5800-5800
set policy from untrust to trust any any realvnc permit
This assumes that the traffic is sourcing from an IP in the untrust zone and your RealVNC server is in the trust zone. The "any any" is the source and destination address, respectively. The set service creates a user define service call realvnc using tcp protocol, allowing traffic to be sourced from all ports above 1024, and the realvnc server is listening in on port 5800.
This discussion is closed to new replies.
Sort by Trending