Question Locked

LAB point to point serial connection

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello All,
I am trying to connect my two Cisco 2600's via a p2p serial connection for my home lab. From all my reading I see you would use a DTE/DCE cable? however, I have a WIC 1 DSU 56K card in each router. They cannot be connected via a serial cable (needs RJ45 port). I currently have a cross-over cable between them. They are still down/down.. with out a config they should be up/down right? Or can you not use these wic cards in a lab setting?

2 replies

by robo_dev

You can also use a back to back configuration for routers that have a WIC-1DSU-T1 or WIC-1DSu-56K installed by using a cross-over cable between the CSU/DSU. The cable pin out is like so:

A 4 wire T-1 cross-over cable uses (1->4, 2->5, 4->1, 5->2)

A 4 wire 56k cross-over cable uses (1->7, 2->8, 7->1, 8->2)

For the T-1 configuration set one CSU/DSU to clock source internal and the other CSU/DSU to clock source line. The linecode. framing, data-coding and timeslots must be set the same on both CSU/DSUs.

For the 56k configuration set one CSU/DSU to clock source internal and the other CSU/DSU to clock source line. On the CSU/DSU with internal clock the clock rate must not be set to auto. Both CSU/DSUs must be set for service-module 56k network-type dds.

And that should do it.

swiped from:
http://www.routerie.com/cgi-bin/ultimatebb.cgi?ubb=get_topic;f=50;t=000066

This discussion is closed to new replies.