Question Locked

Linksys Adhoc Network

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am trying to setup a wireless adhoc network between 2 windows xp machines .both machines are running windows xp pro one is sp3 the other is sp 1 . I have 2 Linksys wrt160n wireless routers loaded with the dd-wrt open source firmware. Both pc?s and both routers are setup with correct ip addresses and both are set on the same channel have the same shared wpa key and are both set to adhoc mode. Both computers are set to the same workgroup. I can ping each router successfully from the computer that it is attached to but when I try to view other computers on the workgroup I only see the machine that I am currently on. I primarily wish to share files between these 2 machines and to install ultra vnc for remote control / admin. Later I would also like to share the internet connection using ics. My primary machine is connected to the internet via a Verizon wireless sub modem. Can anyone point me in the right direction? Any steps that I have missed? Thank you

3 replies

by cg it

in your case, I think you have 3 routers there with the Verizon wirless.

[Typically the ISP modems are really routers with a built in DSL modem and built in 4 port switch as well as wireless].

I suggest you dump one of the wireless routers and just use only 1 of the linksys routers.

To setup a network between 2 hosts, they have to be on the same network and same subnet addressing.

you can setup a network between 2 hosts that are not on the same network and same subnet, but then that's remote access. You can use VPN, Remote Desktop, or one of the 3rd party programs like gotomypc.

by normh3

Since these are in a peer to peer setup, make sure that you have identical users with identical passwords on each PC.

This discussion is closed to new replies.