Question Locked

LinkSys Router Issue?

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have both a LinkSys router 8 port router (no wireless) and a LinkSys cable modem. We have four PCs connected directly to the router - two of them on DHCP and two of them with static IP addresses outside of the DHCP scope (so they can't be accidentally assigned). We also have a wireless router connected to it, where another PC (wired) and a notebook (wireless) connect.

Whenever one particular computer connected to the main router is turned on, we lose connectivity to the router and both it and the cable modem have to be reset. If I unplug the second router's network cable, the same thing still happens so I know it's not that. I suspected a bad port, so I switched that PC to a different port...still no go. The computer that was previously at that spot did not cause this problem, so I don't suspect the cable. Once that machine is on and the router/modem have been reset, everything is fine.

Anybody have an idea what this could be? I suspect it's something Windows-related.

7 replies

by tburns

so let me get this straight you have

1- cable modem
1-linksys router ( not wireless)
1-wireless router connected to the linksys
correct.

Do you have DHCP turned on at both routers. That could be aiding the issue your having.

by rivetgeek

And one thing I'm going to try is to give everyone - all clients, including the wireless router - static IPs.

by mjd420nova

Double check your cable placements away from power cords. There is one bad or intermittent connector and the induced voltage is not allowing a proper reset. A monitor or bit grabber would be needed to find the real cause.

by rivetgeek

I had thought of a bad cable but not the cable placement. The odd thing is that I would suspect the wireless router with the PC hooked up to it would have the problem in this case (due to where the cable runs) and not one of the four on the "main" router. This is now about #4 of additional things to check ;)

by ms.meeh_08

The problem might be on the IP address of either the routers and the modem that you have. To be able for the other router not kick off the other change the IP address of the other router so with the modem. But before doing it consult first the router manufacturer or the modem naufacturer and even your ISP to have you assisted on changing the settings on the devices.

by rivetgeek

I may have the wireless router set an an IP that the other computer is trying to grab. It'll probably be a lot clearer when I get home from work and am just tired, as opposed to I just woke up, and am tired and grumpy (which is where I was at when I was presented with the issue this morning).

This discussion is closed to new replies.