Question Locked

Linksys Wireless N Router speed

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a Linksys Router WRT150N 1.1 linked to my PC via an Adapter WUSB300N-RM 1.01. The spec speed is 300Mbps, but I rarely get over 200Mbps. Any suggestion for improvement, ideas?
Thx, Joe V.

7 replies

by older mycroft

It is NOT de facto.

Sorry, but you're talking wireless here, so an improvement would be for you to start living in the real world.

30 years ago I used to own a Mini Cooper that had a speedometer that showed a top speed of 130mph - with the wind behind me, I could scrape up to 105mph, but I didn't go round moaning about it. ;)

I couldn't find (couldn't be bothered looking any further..) a review of your unit, but here's an excerpt from a review of a Netgear equivalent unit:

[i]"On first contact with the router, the web interface does a quick reconnoiter of Netgear's support site to check for new firmware upgrades and then lets you into the interface. For wireless settings you have an interesting selection of modes. You can have simultaneous support for the 5GHz and 2.4GHz ranges each supporting 270Mbps and 54Mbps speeds respectively or you can go for 270Mbps 2.4GHz instead. You can also opt for single channel wireless-N for both modes which drops speed to 130Mbps. [b]To be honest none of these speeds are achievable in the real world but at least Netgear has stopped the dubious practice of advertising these speeds on the product packaging.[/b][/i]

http://www.trustedreviews.com/networking/review/2008/05/25/Netgear-RangeMax-Dual-Band-Wireless-N-Router-WNDR3300/p1

I think you'll get my drift now. :)

by .martin.

short of attaching the router to the laptop so both antennas are next to each other, even then you wouldn't get 300Mbps.

As Old Mycroft said, 300Mbps is theoretical, so in an magical world where there was no interference, you may get 300Mbps, but not in this world.

only way to get faster speeds is to get a new router with Gigabit Ethernet, and connect it over a wire.

by technogeek-1995

Can't you change the settings in the firmware. Change the "transmission rate" to 300mbps. (if it isn't selected already) I have a pic, but I don't know how to post it.

by older mycroft

'Transmission Rate' is only at source - so you can transmit at 300Mbps and therefore you ARE transmitting at that speed but you have to take into account what speed it is being received at, at the other end. This is wireless after all (and includes non-receipts, re-transmits, error-checks et al).

All of these interruptions to the signal transmission have to be taken account of somewhere, and that is generally in the realm of the eventual throughput. ;)

by older mycroft

How is your sister doing - this fine festive period ?

You never DID tell us how you managed to explain-away the covert webcam ?

Merry Christmas! :D

This discussion is closed to new replies.