Discussion Locked

Loss of Video

0 helpful
19 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a computer system that does the following:
I turn on my computer (cold system) and within about fifteen minutes the screen goes blank. I turn the computer off let it sit for a few minutes, turn it back on it's fine for a about a half an hour, then same thing "blank screen." I have changed video cards, disabled screen savers, power management, I haven't a clue what to do. I'm running Windows 98, with a standard Trident 4MB Video Card, originally the problem started with a SIS 630 8MB Card

19 replies

by richard_barsby

Hi have you tried a different monitor some types do after a while suffer from going into a false power down when they should not.

Rich

by hinrgman

The monitor you are using may be defective. Try another monitor that you know works OK. Hope you did not throw out that SIS 630, it may be just fine.

by thechas

2 heat related things to check.

Is the chipset on the motherboard , (or the CPU) getting too hot?

If the card is an AGP, make sure that it is seating all the way into the slot. I have seen card/case combinations where the card was 1/16" from seating, and that causes AGP to not work.

Also, make sure that your memory modules are fully seated.

Chas

by vtsuk

Has your BIOS got a power saving feature and is it still on?

when you press ALT+CTRL+[DEL] what happens
* nothing
* resets the system with no image
* resets the system with an image
**Other

If you press RESET (if you have one)on the Base unit what happens
* Have not got one
* Nothing
* some beeps and flashing lights
* the system restarts and can see everthing

My power saving, screen saver for windows is turned off but the monitor supports DMPS which I control in the BIOS

Butif I use an old monitor without DMPS and leave BIOS Setting active after 25min the system Freezes

(25mins is my setting for VIDEO OFF/SUPPEND in BIOS)

1) cheak BIOS Power saving
2) Borrow new monitor
3) Try activating windows PM
4) Win the LOTTO buy new system
5) when reading this shut down after 25min

by yu_edwin

Have you checked the "energy saving features" settings? If not go to Control panel then Display settings, Screen saver, at the bottom there should be a "settings" button for that feature and you should see if the power saving schemes are activated and for how many minutes it would trigger the monitor, etc., off.

by csmith

There is nothing wrong with the PC, and the SIS video card is good.
This is a monitor internal power supply problem.
Sometimes there is a faint, high pitched whistle, or a click, from the monitor, before the failure.
A quick test.
You can lengthen the time to failure by reducing the size of the displayed image (Change settings so a black stripe appears around the picture) , or reducing the refresh rate.
(I am assuming the refresh rate is properly set, and Windows knows the make and model of monitor inastalled. The wrong refresh rate can cause this prtoblem.)
The long term solution to this problem is, replace the monitor.
Fortunatly monitors are not so expensive as they used to be.
Regards, Chris

by csmith

Sorry about the fatfinger.
I am not used to this keyboard yet.
Regards, Chris

by csmith

If the Monitor checks out good on another PC, check under Accessories, System tools, System information, Tools, System configuration utility, Startup.
There is a virus that causes blanking.
It will be a checked box with no path after it. (Blank line)
Uncheck the box, and restart.
Regards, Chris

by trippin

computer idling when it goes blank?
if it is... maybe is power management stuff..
if not .. get another monior to sit on the pc... see what happens.. if nothing happens.
you know what to do ..
:)

by sales

Check your BIOS for power management settings. They are different than the Windows power management settings.

You could also have a monitor thats over heating. try another monitor and see if you have the same problems.

This discussion is closed to new replies.