Question Locked

MAC Authentication on 3570 switch

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I know that I can do port authentication on the Cisco 3750 switches, but its not clear to me if MAC address authentication can be done. Is anayone doing this on the switch?

2 replies

by aarongreenag

There are a few methods that I can think of off of the top of my head for authenticating ports at Layer 2 (before IP addresses)

1) Use 802.1x authentication. This is a pain, and as far as I understand, it can't be controlled through Group Policy, but it will do the trick. Commonly used as a starting point for Wireless networks.

2) Use IPSec. A little over the top for port authentication, but can also be leveraged to secure communications while you're at it. Essentially it will force all clients to negotiate a security association, and if they can't negotiate, the connection is smoked.

3) Limit the number of MACs allowed on a switchport. This is programmed on the switchport in Cisco IOS, and will combat CAM flooding by only allowing the switch to learn a few MACs at a time.
ie: switch(config-if)#switchport port-security max-mac-count 2

4) Dynamically learn the SINGLE MAC that is currently on the switchport, and remember that one, do not allow any other MACs to use the switchport.
ie: switch(config-if)#switchport port-security mac-address sticky

---------------

1) Port Authentication
2) IP Authentication
3) Shared Medium MAC limiting
4) Single MAC permitted, doesn't combat spoofing

This discussion is closed to new replies.