Question Locked

Many .SYS files corrupted - XP won't boot (PCI.sys, NVATA.sys)

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Windows XP Pro (32 Bit)
AMD64 4000+ Dual Core / Nvidia Board
2 Gigs Ram

Any help greatly appreciated!

It started with the "cannot start windows because PCI.sys is missing or corrupted" problem. I used the XP install CD to restore (expand) pci.sys. Upon reboot, it had a problem with another .sys file, which I restored as well. That one cleared, and it's now looking for nvata.sys, which is not on the XP install CD. (Maybe it's associated with the board?)

I tried Automated System Recovery (ASR), but it wants a floppy, and i have no floppy drive. I did a disk check (full) on the HDD with Western Digital software; no errors.

Before the failure, I had just run Windows Update, and installed Blackberry Desktop software.

Any idea what to do next, other than reformat and hope for the best? (I have my files backed up :) ) I'd even consider swapping files through a Linux boot CD if that would help. Anything that's less than the 4 hours it'll take to reformat and restore...

Thanks!!

4 replies

by p.j.hutchison

I suggest a repair install, but booting off the XP CD, select Enter to install XP and press R to repair XP. Then you won't loose settings.

Otherwise I suggest a clean install.

by dgill1

I ran into the same problem (after installing dual Nvidia graphics cards). At first the cards installed and ran properly, but after a very short period, the system wouldn't boot up. It first gave the pci.sys is corrupt or missing message (it wasn't missing, so I guess it was corrupt), but after fixing that problem, it said that the nvata.sys was corrupt. The nvata.sys is not on the Windows XP CD, so it must be on the Nvidia driver CD. Is there a way to boot in repair mode and copy from a different CD other than the Windows XP install CD?

I wonder if the original poster also had dual Nvidia SLI based graphics cards.

by p.j.hutchison

You can actually install the recovery console on your PC w/o having to boot from any CD by using the command winnt32.exe /cmdcons.

You can boot from any good Linux Live CD with NTFS r/w facilities to do Windows repairs.

This discussion is closed to new replies.