Question Locked

Memory Installation

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I recently decided to upgrade my laptop's( Toshiba Satellite A135-S7404) memory from 1.5 gig to 4 gig. The memory that i bought to do this is, Crucial 200-Pin DDR2 SO-DIMM DDR2 667 (PC2 5300). The problem is that when i tried to boot my computer, It wouldn't work. I then tried different combination's of sticks and the only 2 configurations that would work were the original 512 and 1 gig sticks and also one of the new 2 gig sticks along with the original 512 stick.
I have no clue why this would happen and any feedback would be great.

thanks

7 replies

by older mycroft

I was going to post that the link posted above was slightly off-target - and did actually post with what I thought was the CORRECT link for the System Specs page - then checked it and it led straight back to the page I had objected to originally. ;)

So - when you open the link, click on the System Specs [TAB] to read the memory limitations for this Tosh 'puter. :)

by lichoro1

Right now, I have a 2 gig stick and a 512 stick installed, which is over the 2048 limit. How does that work?

by older mycroft

But it probably isn't.

However, being that it's only a 512MB ram, it's probably not drawing anywhere near as much DC current as a second 2GB RAM would be sucking out of the laptop.

Your BIOS is probably only seeing the single 2GB RAM SODIMM.

Mind you, MAYBE your BIOS is only seeing the 512MB RAM - depending on which RAM module is fitted to which memory bank!

This question is irrelevant anyway - the Toshiba specification for your Toshiba stipulates that the maximum working memory is 2GB (preferably 2 x 1GB RAM SODIMMs).

by thechas

The fact that you can boot with more than the specified 2048 MB of RAM installed in no way implies that the system is as stable as it could be. Or that it will be reliable over time.

I did not read the manual past verifying the RAM limit. I also checked the BIOS update posting to make sure that a BIOS update had not increased the available RAM.

Since Toshiba publishes a 2GB RAM limit for this system, I would stick with it.

My personal preference for the configuration would be to have 2 1GB DIMMs installed.

Keep in mind that on a 32 bit Windows installation that any RAM over 3GB is NEVER going to be used. As much as the upper 1.5GB of the 4GB address space is reserved for the chip-set. So in very real terms, there is no benefit to be gained by installing more than 3GB. That is, other than increasing the power used by the computer.

Chas

by larryd4

I was on the way out the door when I posted that and it was a bit backwards.. I can see how it looked,

This discussion is closed to new replies.