Question Locked

Memtest86 Error Message

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
When using MemTest86 Ver 3.5 the program froze on the second pass with the error message "unexpected interrupt - halting CPU". On one pass the program had found 2 errors on one DDR memory module (module 0) before it froze and on another pass it found one error on both of the two modules. Incidentally, Windows Memory Diagnostic program reports many errors on both modules but mainly on module 0. I get better results when caching is turned off. The reason I'm testing the memory is because the notebook has started to crash unexpectedly (BSOD) after a prolonged period (4 days) on standby. Can anyone tell me what all of this may mean?

3 replies

by older mycroft

What it means is that healthy stable RAM would allow MemTest86 to run all night long and not return any errors.

by oh smeg

It will cost more in your time than the new RAM is worth to make this unit work properly.

You already know that the RAM is faulty so the most likely problem with this NB is the RAM, unless of course there is something else more obvious like a Star Picket stuck through the middle of the NB or a big hole from blown components as the exited the NB.

But if you have not already done this remove the RAM and clean the Gold Edges with a soft Rubber/Eraser and refit it. Sometimes just removing and refitting it will clear any corrosion that has formed on the contacts. However this should have been done before you started to run Mem tests.

Col

This discussion is closed to new replies.