Question Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Whenever I turn on my computer and start to work, after a few minutes the monitor starts to black out -- half the screen will turn black from the bottom going up, and this problem corrects itself if I tap on the back of the monitor. What can i do to correct this problem? I have a HP compaq system using Windows XP that is approx. 18 months old and off warranty.
3 replies
by drea6345 Accepted solution
Clarifications
by letmein666 Accepted solution
if its a CRT i would just chuck it and get a replacment, if its a TFT it might be worth opening it to check for a loose conection or a dodgy solder point.
by w2ktechman Accepted solution
If so, I would suspect your video card, if it behaves the same then I would say to replace the monitor or send it to a service center.
The problem with the service center is that it may be cheaper to replace it outright than to have it repaired (unless it is under warranty).
If it is under warranty, DO NOT follow the first persons advice and open it up. You may just void the warranty on it.
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending
1 helpful
15 replies
Question
Is WSL still relevant in 2026?
0 helpful
1 reply
0 helpful
2 replies
0 helpful
10 replies
Question Unanswered
i need help in transferring my bulk emlx files
0 helpful
0 replies