Discussion Locked

More on PCs not getting to the Internet

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
We have a home network with 2 PCs. Lately, when one PC is on the internet, the other cannot get on and vice versa. What could be happening? Both our PCs are running XP. The Cable runs to the router, which runs to the hub, which we both hook into. If one PC wants to get on the internet it has to restart to do so thus knocking the other off. We have road runner and they have basically said its a problem with the hub. I called the manufacturer of the hub and they say its a problem with road runner. I am running in circles--please help.

11 replies

by vic66

It looks like you're sharing one IP address...and only one computer can use it at one time. Check the DHCP setup on your router to make sure that it's configure with a range of IP address to use for your other computer.

by tech

I think what happens is that your router clone the MAC address of any of the PC that first connects to the cable...

Have you tried to find the settings regarding the MAC address? Try to use the MAC address in the router instead of spoofing the MAC of the computer connected to the network on a specific IP.... I've heard of some cable companies who check if you are a valid user based on the MAC address...

In order to perform this, follow these steps:
1. Set the router to get the MAC address from the internal
2. turn off both PC and restart your router
3. Turn off your cable/DSL modem
4. Turn on your Router
5. Turn on your Cable Modem
6. Turn on your PCs...

Hope that this help...

by wrharvey

A HUB alone attached to the modem will exhibit the symptoms you describe. You can only have one pc attached at a time. And rebooting may change who is attached.
If you have a multi port ROUTER then you should have no problems. (I run four PCs thru a router using RR.) RR assigns the dynamic IP to the router and the router sends the packets to the applicable PC. With a HUB attahced to the cable modem the IP is assigned to the first PC RR sees. Since you may only have ONE IP from RR the second unit is locked out. When you have a router and hub in series I am not sure what happens. I have one hub in line to "extend" the reach of one cable and that seems to work OK.

That is my understanding and experience.

This discussion is closed to new replies.