Discussion Locked

Motorola SM56 speakerphone modem driver

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,
I'm having an internal Motorola SM56 speakerphone data/fax/voice modem. However it is not installing on my windows XP OS (SP2). I've been searching for the proper driver, but unable to find. It is not available even in the motorola site.
For Some reason Motorola has taken out the link to the update for this driver (year 2003 build)
I tried some drivers from the web, but they still didn't help. The driver installs, but in the end it says that the device couldn't start code 10.
Do you know where to find the driver which works?
Thanks

11 replies

by hozcanhan

david hi ! I had exactly the same modem . It is not expensive , my advice is replace it . But if you don't want to then use the standart modem option in the XP standart hardware list . Yes you will use it with less performance but it will be less problematic. No spare driver can alleviate the problem . It didn't mine , anyway !

by hozcanhan

david hi again ! ok , first remove any modems in the control panel's enlisted hardware list . also from the windows entry disable plag and play property . ( or at worst disable the motorola modem ,i.e. disactivate this hardware in the hardware list ). boot the pc and make sure the modem gets an irq that you define ( 3 or 4 or 5 ) note it down . then boot with safe mode . add the hardware as standart modem . you should be able to get a detailed info when checking the modem . reboot and use it . good luck !

by hozcanhan

david , in the bios disable the serial ports of the mother board as well . you might be having a conflict with the serial irq s . then while the system is booting look carefully at the very beginning ( press esc if necessary ) when it displays mp,ram,disk etc. to see the irq of the motorola modem . when inside the operating system check in the hardware diognostics if the irq numbers match .

by davidfranks78

Hi Hozcanhan,

I tried installing a standard modem. the modem installed, but it didn't work at all. The Query modem command didn't work. Is there something I need to do? If I'm able to get this modem working this way, I'm willing to award full points to you.
Thanks for your help

by davidfranks78

Hi Hozcanhan,

I tried as per your 2nd instructions, but it still didn't work. How to get the IRQ for the modem? Does this need to be done in normal mode?
Sincerely,
David

This discussion is closed to new replies.