Question Locked

Moving an Exchange server

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
A predecessor of mine installed Exchange onto the same server with the PDC (Active Directory). Although this makes some sense from an adminstrative standpoint, I believe it causes more headaches and is not the correct standard. I would like to move Exchange to another server but I can't seem to access the Exchange System Manager. Any tips, pointers and white papers on this subject would be greatly appreciated.

5 replies

by reb00t

rather than move exchange. Moving exchange can be a 30 minute thing or it could be a 2 day thing. It all depends on the luck of the draw and how f'd up your environment is.

Again, personally, I would move AD off of the server.

by bak2009

I actually had started to move that way as an option as well but wasn't sure if I should move Exchange or the PDC.

I created a test server and deployed it as a secondary domain controller already. What are the steps to make that the primary controller?

Thanks for your help!

by reb00t

What you have is a PDC emulator role. For lack of a better term, you can call this your primary domain controller.

Basically, to decommission your old one, you would move all your FSMO roles (search MS KB) and then run 'dcpromo' on that DC and decommission that role.

by jtakiwi

1, you cannot open exchange manager, and 2, you want to move exchange to another server. I'm assuming exchange is working as is, as in email is being sent/recieved fine? If so, you need to figure out why you cannot open exch manager, which may be as simple as permissions, either within exchange or even the shortcut/executable that runs exchange manager. To move exchange, search on exchange 2003 migration. The broad strokes steps are (again, assuming your original setup is fine and you want to keep it) are to stand up a new exch server, join it to the same exch organization, move the mailboxes to the new exchange server, move your smtp connector(s) and free/busy connectors, public folders, etc... to the new server, make sure it all works, then uninstall the old one. Now, if your current setup don't work, then blow it away, and just start over on the new system.

This discussion is closed to new replies.