Discussion Locked

MOVING AN HARD DRIVE TO A NEW SYSTEM

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

CAN SOMEONE PLEASE TELL ME THE PROPER WAY TO MOVE A EXISTING WINDOWS 2000 CONFIGURED HARD DRIVE WITH ALL MY DATA FROM MY LAST SYSTEM TO A NEW COMPUTER SYSTEM THAT HAS NEVER HAD A HARD DRIVE ?

WHAT ARE THE RISKS CONCERNS PROBLEMS AND CORRECT WAY TO DO THIS.

5 replies

by mrafrohead

The correct way to do it would be to backup all of the data that you will need saved, documents and the like, and then do a FRESH install of your OS after you have cleaned the hard drive.

Reason being. If you are switching Windoze 2000 to a new computer, it has already configured itself for the motherboard and peripherials that you have on your current box. After you switch it to a new box with a new motherboard and hardware it will auto configure itself and associate itself with the new hardware. BUT the likelyhood that you will have bugs and issues are VERY VERY high!!! Not to mention things just won't work like the would with a fresh install.

So, to answer your question. Backup data, Clean the Master Boot Record, Format the drive and then do a fresh install of your OS...

Mrafrohead
@yahoo.com

message me if you have any questions or need any help;)

by soylantgreen

Make sure you backup your data 1st!

Set BIOS on new PC to Auto detect new HDD.
"If" the PC boots from the HDD WIN2K should automatically detect the changes from one PC to the other and make the changes for you. You should have the drivers on hand for your periphrials (video, NIC, etc..) just in case.
After 1st successful boot, go into Device Mgr., then System Devices and check for conflicts.
Conflicts to look for:
Duplicates of any type.
PCI to ISA bridge from OLD machine
Incorrect AGP controller
Incorrect PCI bridge

Hope this helps...

by isys

Then install the drive in the new box. At the first bootup it will detect the new system drivers and install them (but you might want to have the W2K video, modem and NIC drivers handy). It shouldn't be any harder than that. But the backup will give you the assurance that, if anything does go wrong, you will be able to get back to your starting point.

by radiic

I have switched harddrives to another pc, but before shuting down the old pc....Go into device manager and remove almost all of the devices. Not the mouse unless your good with the shortcut keys on a keyboard (like us oldtimers). Then shutdown the pc...move the drive to the new machine and let it boot up...it will start detecting all the devices...You will need the cd of drivers for the new mb and run those first so that it will start putting in all the right bus info. Then look and check device manager to see what has the old exclamation mark next to and update the drivers of those devices. Should work for 2k too...Matter of fact I would bet that 2k would do better than 9x with the switch.

Good Luck
Rad

by mtberjim

And delete all the devices from the device manager. Shut down the computer remove from old and install in new. reboot and let it find and install the devices. If you have data that you cannot lose, I would make a ghost image of the drive first, on asecond hard drive. This way if it becomes corrupt you can always just plug it back in the old one. Good luck, Jim

This discussion is closed to new replies.