Question Locked

Multihome - 2 Subnets on 1 NIC

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have 2 Subnets that I am trying to access via the one NIC my PC has. I've played around with the TCP/IP Properties/Advanced. Tried adding a 2nd Gateway with a higher Metric, tried having no gateway, tried adding a static route with the "route add" command, and nothing seems to work.

Anyone has any ideas?

8 replies

by downrighttired

what exactly are you trying to do? what kind of hardware/wiring is between your nic and the 2 subnets?

by denio

Wiring is just Ethernet to Switch for one subnet which in turn is connected to other subnet switch.

192.168.0.0 subnet 1
192.168.1.0 subnet 2

by cg it

the NIC can only function using 1 subnet addressing at a time. Want 2 subnets? either use hardware profiles or stick a second NIC in there. laptops with wireless and wired NICs works this way. One is active one is not. The laptop uses which ever one is active most cases the wireless. If you want to use wired the wireless NIC needs to be disabled or you use a hardware profile that will disable the NIC [wired/wireless whichever].

you could try NLB, that might work

by downrighttired

isnt there some ipconfig command that lets you set a sub-interface like on a router? I know you can do it in linux, seems like i found a way in windows but just played with it and dont remember.

by denio

I checked that out but it dosen't do it. I was following the official instructions on MS Technet to "configure a multihomed system using a single network adapter" but that didn't work.

I'm just going to have to get a second NIC.

by denio

Yeah, I know on a laptop a 2nd hardware profile works fine. But since MS Technet said that it was possible to have multiple IP's for separate subnets, I was trying to avoid buying a second NIC.

by downrighttired

now I remember how i did it in windows. I was using VMWARE which allows you to add virtual NIC cards. I was thinking of IFconfig in linux...

This discussion is closed to new replies.