7 replies
by sfjttgm Accepted solution
by cg it Accepted solution
by sfjttgm Accepted solution
by cg it Accepted solution
as global local addresses but with many to one, one to many NAT allows less global local adresses hense lower cost than getting expensive public addresses from the ISP. Thats why I said to get a 2800. You can use NAT on the total WAN addresses you have so that hosts on subnets behind the router don't need a public addresses.
what do you have, a dedicated leased line or frame relay? certainly, most have a PIX or something in front of any WAN connection unless its a dedicated line.
Again a router with NAT will solve your problem .
by sfjttgm Accepted solution
by cg it Accepted solution
7' racks and cabinets can hold a lot of stuff.
saving addresses...NAT saves you addresses no matter which way you look at it.
All I can say is put your new pool into your layer 3 switch route table. you can't use VLANs on the same switch unless you can route between them [well with a layer 3 device you could]you could trunk VLANs on seperate switches, but thats all a lot of work and admin effort that could be avoided with a layer 3 device with NAT
by sfjttgm Accepted solution
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending