5 replies
by daisy_m_reyes Accepted solution
by captbilly1eye Accepted solution
Verify the power supply and the connection from it to the drive are valid and secure.
Make sure the jumper on the back of the drive is set to Slave.
Connect Master and Slave drives using the same ribbon cable (assuming you are using IDE).
by oh smeg Accepted solution
If it's a SATA Drive you most likely need to install the SATA Drivers. If that is the case you shouldn't see the Drive in BIOS or anywhere else until the OS is loaded and working properly with all the necessary drivers installed.
If it is an IDE Drive sometimes called PATA and you are unable to see it in BIOS the Hardware isn't properly setup.
Col
by aleczee Accepted solution
by captbilly1eye Accepted solution
Were you able to resolve your issue?
If so, what was the ultimate resolution?
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending