Question Locked

my d600 latitude powers on but blank screen comes on and shuts off

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
i have a d600 laptop latitude that excepts a charge but when i turn it on it is a blank screen and then shuts off after about 20-50 seconds i figure it could be the system board but i dont know i tryed to hook it up to a crt moniter because i thought it was the lcd then checked the ram no luck there and switched out the hard drive i am pretty much stumped so i think its the system board please help me thanks

3 replies

by nepenthe0

1) Download the service manual:

http://tinyurl.com/9lqz4

2) Check the battery. Laptop batteries have a rather short life: 12-18 months of useful service. After that, they rapidly lose efficiency, and eventually cannot hold enough charge to boot the computer.

Measure the voltage across the battery terminals. It should be close to that printed on the battery label. If significantly lower, the battery has failed and must be replaced.

Even if the voltage is close to the designated value, I would recommend having the battery load tested at a facility such as Batteries Plus:

http://www.batteriesplus.com/

If the battery fails a load test, it should be replaced. I recommend replacement with an original equipment battery. There are services that will refill the battery case with new lithium cells, such as BatteryRefill.com

http://www.batteryrefill.com/

which is half the cost of a new battery from Dell. The down side: you are without a functioning computer until you receive the refurbished battery.

Rick/Portland, OR

by cmiller5400

Do you get any beeps or error messages? Does it sit there with no video and no beeps, then shuts down?

I would try taking out the memory and boot the system. If it beeps at you (noting the beep code to look up in the service manual), it is probably the memory so swap the memory with a known good chip. If still nothing, make sure that you remove all peripherals, and the battery. Boot only with A/C power. If still nothing, then it is either the processor or motherboard.

This discussion is closed to new replies.