Question Locked

My Network and Layer 3 Switching and VLANS

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Please help me understand a couple of things about my network, layer 3 switching, and VLANS.. I'm confused as hell about this stuff for some reason, I usually grasp such concepts so it's frustrating. We had a network which was entirely Layer 2 in nature, but then one switch that went bad and started screaming took the entire network down to it's knees... Being that this is a hospital we have flagged one segment of this network as "critical" and wish to protect it from such network storms. Problem is that it must be able to contact a few of the same servers and services as the rest of the network.

Most of the network is running on managed Layer 2 switches that are VLAN enabled and I do have two layer 3 switches available.. What would you all recomend for my VLAN configuration and placement of two available Layer 3 switches to protect the critical portion of the network from everything else without loosing the connection to the servers?

If I had a storm on the noncritical portion of the network would it cripple the servers as well? Can I stop that possibilty with layer 3 switches when the servers have to be on all VLANs?

Thanks :)

4 replies

by hawkin96

Use the L3 switches to segment the rest of the flat L2 network, and PVST to protect L2. Put the servers on a different vlan, and in a different spanning tree (STP) group. I would also extend a L2 switch from the L3 switch to service the servers. The L3 switches will provide segmentation from a broadcast perspective, and the different STP group will provide link state isolation.

by cg it

your layer 3 switches would provide inter-vlan communications if configured accordingly.

If you want to segment hosts in your broadcast domain on a layer 2 switch, you create VLANs and assign switchports to the VLANs you want those hosts to be members of. Those VLANs create a seperate collision domain that each switchport [and host on that switchport ]are members of that VLAN. If you have multiple vlans on multiple switches you create a trunk line to allow vlans on one switch to communication with it's corresponding vlan on the other switch. For inter-vlan communications, you need a router [layer 3 device] that will router traffic between VLANs. note trunking allows VLAN communications between same VLANs on different switches. [Blue VLAN on switch 1 talks to blue VLAN on switch 2 via the trunk line.]

If you have broadcast storms, you've got something else serious going on your network that you need to address.

for redundant path loops enable STP.

This discussion is closed to new replies.