9 replies
by darmstadtrunner Accepted solution
by tintoman Accepted solution
by darmstadtrunner Accepted solution
I tried this and it worked on the second try. I had to set the jumper on pin #3 which really does nothing and it booted up and worked fine on the second try. Setting the jumpers on CMOS - normal didn't allow a full boot-up. I took the printer and external HD USB connections off the first time, but put them back the secondd time and it worked. I'm still amazed at what can happen to a PC and what great people are out there to help. Thanks everyone for the suggestions. I'm saving them for future reference.
by older mycroft Accepted solution
All external USB HDs should be treated in exactly the same way as you would treat (or at least SHOULD treat) a USB Thumb Drive.
Just as you should use the Safely Remove method when disconnecting a thumb drive, you should employ exactly the same practices with a USB HD. If you don't, one of these days the USB HD will be dead or at the very least its partition tables will have been corrupted. Your stored data could then very well be lost forever.
USB HDs are not designed to be connected all the time and are certainly not designed to be attached at boot or at shutdown.
You should always Safely Remove them prior to shutdown and only attach them after booting up.
by older mycroft Accepted solution
Download [b]UBCD[/b] - Ultimate Boot CD - and burn the ISO image to a CD.
You then boot from the UBCD, which has its own self contained operating system (so it bypasses Windows and whatever is on your hard drive).
Once the UBCD is running you can utilise the diagnostics software it contains to check out your hard drive(s) and RAM and other ancillary hardware.
by ---tk--- Accepted solution
by 1bn0 Accepted solution
Make sure the CPU, Power Supply, Video card fans are all clean and moving freely.
Also inspect the motherboard capacitors for signs of leaking or bulging tops.
http://en.wikipedia.org/wiki/Capacitor_plague
These are both common causes of boot failure.
by snuffy09 Accepted solution
do you have any external devices hooked up to it? Like USB Hard drives or Printers. if an external HD is failing this could cause a stalled boot problem.
Your Power supply may also be failing.
I think if your Motherboard was dead or dying you would not see the intel splashscreen, but if it was working properly it should at least POST.
to see if it is the HD try unplugging the power from your internal HD and then power on the PC. if the mobo posts then it may be the HD is failing.
by darmstadtrunner Accepted solution
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending